Taurus HOMELAND UNIQUE Bedienungsanleitung Seite 9

- When the battery is charged disconnect the
charger from the mains supply.
- NB: Do not use the appliance while it is con-
nected to the charger.
HOW TO CHECK THE BATTERY'S CHARGE
LEVEL:
- Press the ON/OFF button (G), the pilot lights
that indicate if it is charged will light up.
- If all four pilot lights come on this means that
the appliance is fully charged.
- If no pilot light lights up, this means that the
battery is completely flat.
- NB: For a long battery life, it is advisable to
charge the battery, only, when it has run out
completely.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that product's packaging has been
removed.
- Before using this product for the first time, it is
important to make a full charge of batteries.
- Prepare the appliance according to the function
you wish to use:
USE:
- Turn the appliance on, by using the on/off
button.
- Select the desired speed with the speed selec-
tor. (N) This function is very useful, as it makes
it possible to adapt the speed of the appliance
to the type of work that needs to be done.
FITTING AN ACCESSORY TO THE HAND
VACUUM:
- The hand vacuum is designed in such a way
that it allows the following accessories to be
fitted: (use the combination that best meets
your requirements). (Fig.1).
- Furniture brush: Equipped with a brush at the
end, which brushes the surface as it is used.
- Crevice nozzle: Specially designed for getting
into cracks and difficult corners.
- We can insert the accessories into the tube.
- Press the button to bend the flexible tube and
access hard-to-reach areas. (Fig.2)
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button.
- Clean the appliance.
CLEANING
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
- Empty the dust box when it is full (observation
facilitated by transparent windows), or when
vacuuming power is notably reduced.
- Open the lid of the dust box pulling the ring to
open the lower tank cover (M) located on the
inside of the handle and empty the contents
into the appropriate waste disposal receptacle.
(Fig.3)
- Check the condition of the dust box filter.
CHANGING THE FILTERS:
- Dust tank EPA filter (high efficiency air filter
that efficiently retains spores, ash, sawdust,
pollen...), it is advisable to change it a least
once a year or after every 50 hours of use, or if
its potency diminishes remarkably.
TO REMOVE THE FILTERS:
- Remove the dust bin by turning to the left, as
indicated by the arrow and the padlocks on the
side of the bin. (Fig.4).
- Remove the filter from its mounting by turning
the filter to the left, as indicated by the arrow
and the padlocks. (Fig.5).
- To reassemble the filter, proceed with the
above instructions, in reverse order.