Taurus WALK ON WATER HOME Bedienungsanleitung Seite 10

HOW TO CHECK THE BATTERY'S CHARGE
LEVEL:
- Press the ON/OFF button, the pilot lights that
indicate if it is charged will light up.
- If all three pilot lights come on this means that
the appliance is fully charged.
- If no pilot light lights up, this means that the
battery is completely flat.
- NB: For a long battery life, it is advisable to
charge the battery, only, when it has run out
completely.
ASSEMBLING THE HANDLE
- Press the release pin.
- Now insert the handle into the body, until the
pin reaches the hole, click and engage the
handle. (Fig. 2)
ROLLERS ASSEMBLING
- The drive shafts as well as the cleaning rollers
are respectively marked in color.
- Make sure you have the same color roller
- Put the rollers on the drive shafts and then turn
the cleaning roller until it clicks into place. (Fig.
3)
ELECTRIC MOP PARKING
- Place the hard floor cleaner
- on the basis of cleaning and parking. (I) (Fig.4)
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that product's packaging has been
removed.
- Before using this product for the first time, it is
important to make a full charge of batteries.
- Prepare the appliance according to the function
you wish to use:
FILLING THE WATER TANK
- Remove the water tanks. (Fig. 5)
- Open the lid of the fresh water tank. (Fig.6a)
- Fill the water tank to the recommended level of
approximately 300ml. (Fig.6b)
- Close the tank lid. (Fig.6c)
IMPORTANT: We can add a few drops of deter-
gent for floors without foam.
USE:
- Turn the appliance on, by using the on/off
button.
- The cleaning rollers start to rotate and become
moistened with the water from the clean water
tank.
NOTE: It may take a few minutes for them to be
100% wet.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button.
- Clean the appliance.
IMPORTANT: Empty the clean (F) and drity (G)
water tank.
CLEANING
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
CLEANING THE DIRTY WATER FILTER
- Remove the protective cover from the dirt filter
(K) by sliding the fixing tab(Fig.7)
- Clean the protective cap and the dirt filter in
cold, running tap water(Fig.8)
ROLLER CLEANING
- Place the electric mop on the cleaning and
charging base for self-cleaning.
- Put 100ml of clean water on the base(Fig.9)
- Press the ON / OFF button (A)
- The rollers start to rotate and cleaning takes
about 3 minutes.
DRYING THE ROLLERS
- Remove the rollers from their anchor(Fig.10)
- Place the rollers to dry in a vertical position at
the rear of the cleaning and parking base (I)
(Fig. 11)