Canon imageFORMULA R10 Einrichtungsanleitung Seite 4

volume. Click [OK] to continue. For details, refer to
"When Using macOS Big Sur" in the User Manual.
• If CaptureOnTouch Lite does not start, take the
following measures.
- Disconnect and reconnect the USB cable.
- If the scanner and computer are connected via
a USB hub, remove the USB hub and connect
them directly with a USB cable.
- Check whether access to USB devices is
prohibited by security software, and allow
access if it is prohibited.
- In Windows, AutoPlay for USB memory
devices may be off. In that case, open
Explorer and run the [CaptureOnTouch Lite]
icon in [Devices and drives].
Raise the document guide.
4
Load the document.
5

Turn the document upside down with the back
side facing you, and load it into the feed tray.
 Align the document guides with both edges of the
loaded document.
Hint
• Press the document beneath the tabs of the
document guides.
Tab
2
Select the document type and scanned
6
image storage location.
Hint
• Clicking allows you to change the scan type
and select a location to save your document.
• Clicking [New document] allows you to add new
settings.
• Clicking [New output] allows you to add new
storage locations.
Click the [SCAN] button.
7
When the software is open, you can also start
scanning with pressing the start button on the
scanner.
After confirming the scanned image, click
8
the [Finish] button.
Click
Click