Segmentation Mode
Select the segmentation mode, add a path (Click
that can be added, click confirm before adding the next path). Slide the S operating point
and the E operating point to any position to set the starting position and end position of
the first path. Slide the E operating point to set the end position of the second, third,
fourth or fifth path. Then, the starting point of the next path will be the end position of
the previous one.
Tap to
delete
the
path
Tap to
reset the
path
Click
to confirm the path and set the running time. After confirming the first path,
another path can be added. Tap Confirm and the SLYPOD PRO will run according to
programmed movement. Using Segmentation mode and the camera connection cable
the SLYPOD Pro will activate the camera's shutter for a motion controlled time-lapse.
Path
number
S operation
point
E operation
point
Tap to add
the path
to add the path. 5 paths is the most
Click to confirm the
path before adding
the next path.
12
Tap to the red
area to set the
running time
Tap to the red
area to set the
running time
End (number
shows the
distance from
the origin)
Click to start