Attach the supplied wires using the
bell wire screws (3). Using the
supplied wire clamps, connect the
wires to your bell wires.
(Note: the arrangement of the wires
is irrelevant).
After the mounting plate and mounting
bracket (optional) have been installed at the
mounting location, place the ProV1 on the
mounting plate until it is firmly seated. See
safety screw on page: 73
Press the doorbell button of the ProV1 to ensure
that the power supply is working. If you have
already connected the ProV1 to your
WiFi, the ProV1 should automatically
reconnect to your WiFi after a few
seconds.