Other Functions; Anomalies Solutions - PHOINIKAS Q1 Bedienungsanleitung

10

Other functions

1. When Line In inserting is detected, switch to Line In mode, disconnect Bluetooth
and all indicator lights are off. When pull out Line In, reboot and connect to
Bluetooth automatically;
2. Low voltage alarming, when the voltage is under 3.3V, it makes "beep" alarming.
Insert the DC power source and it works normally;
3. Undervoltage automatic power off, when the voltage is under 3.3V, Bluetooth
automatically turns off the device. And after re-charging, press the power button to
reboot.
4. Intelligent charging management, insert the DC power source, red light of two-color
LED indictor light is on. When charging is completed, red light is off.
5. When has incoming call, music will be cut off automatically , and press button
answer the phone. When hang off, press button
automatically.When the guy who call and hang off first, without any operate, music
will connect automatically.
6. When playing music, continuously short press the phone button twice to redial the
last incoming call or outgoing call.
The connection between the Bluetooth headset and computer
1. If the computer does not come with Bluetooth capabilities, please purchase
additional Bluetooth adapter;
7
11
,
, and will connect with music
2. Insert the Bluetooth adaptor in the USB interface of computer, install Bluetooth
adapter driver according to the computer tips, and the specific steps are as follows:
A)Open the control panel and select the "Sounds and Audio Devices"
B)Select the "Audio" tab, and select the installed Bluetooth sound device in the
"Playback Device" and "Recording Device" , and select OK after setting and then
exit.
C)hen select the "Voice" tab, and select the installed Bluetooth sound device in the
"Playback Device" , and select OK after setting and then exit.
3.Open the Bluetooth management software, and press the function button on the
Bluetooth headset for about ten seconds. When the two-color indicator light flashes
alternately every few seconds, it indicates that the Bluetooth headset is in pairing
state, only in this case, Bluetooth adapter is likely to search for the Bluetooth
headset;
4.Click "My Bluetooth" and select "Search for Bluetooth Devices" to search the
surrounding Bluetooth devices such as Bluetooth headset;
5.If there are Bluetooth devices nearby, then the searched devices will be listed;
6.Right-click on the searched device and then select "pairing";
7.Enter "0000" as the pairing code in the dialog box;
8.If the computer comes with a Bluetooth adapter, and the drivers and software are
installed, first start searching. If the Bluetooth headset is searched, connect directly
and try the Bluetooth headset, if there is sound, then setting is successful.

Anomalies Solutions

1.The mobile phone can't search the Bluetooth headset?
A) Confirm if Bluetooth headset is power on or off (if power on, blue and red indicator
light flash alternately)
B) If it is power on and still can't search, please reboot Bluetooth and mobile phone.
2.After connecting the Bluetooth headset and mobile phone, disconnection or noise
occurs?
A) Bluetooth power is low, you need to charge the Bluetooth headset as soon as
possible;
B) There is obstruction between the phone and the Bluetooth or the distance exceeds
the signal reception distance, please do not put your hand on the Bluetooth. And in
8