Turn Radio-Controlled Clock On / Off; Set Clock; Switch Clock Display; Alarms - Oregon Scientific BAR908HG Bedienungsanleitung

TURN RADIO-CONTROLLED CLOCK ON / OFF

If you wish to manually set the clock, you must first
disable the radio-controlled feature. To do this, navigate
to the Clock / Alarm Area. Then, press and hold DOWN
on the main unit for 2 seconds. To enable it, navigate
to the Clock / Alarm Area, then press and hold UP for
2 seconds.
RF clock enabled:
RF clock disabled:

SET CLOCK

You only need to do this if you have disabled the radio-
controlled clock, or if you are too far from a RF signal.
1. Press SELECT to navigate to the Clock Area.
will show next to the Area.
2. Press and hold MODE for 2 seconds.
3. Select the time zone offset hour (+ / -23 hours),
12 / 24 hour format, hour, minute, year, date / month
format, month, date and display language.
4. Press UP or DOWN to change the setting.
5. Press MODE to confirm.
BAR908HGA: Select the time zone: (0) Pacific, (+1)
Mountain, (+2) Central or (+3) Eastern.
NOTE
(F) French, (D) German, (I) Italian, and (S) Spanish. The
language you select determines the weekday display.

SWITCH CLOCK DISPLAY

Press SELECT to navigate to the Clock Area.
next to the Area.
Press MODE to toggle between:
• Clock with seconds
• Clock with day
• Clock with time-zone offset
• Calendar
SET

ALARMS

This product has 2 alarms: The Daily Alarm and a
Pre-Alarm for snowy weather. The Daily Alarm can be set
to go off at the same time every day. The Pre-Alarm sounds
only when the Daily Alarm is activated and the recorded
temperature from Channel 1 Sensor falls to 2°C (35.6°F)
or below.

SET DAILY ALARM

1. Press SELECT to navigate to the Clock Area.
will show next to the Area.
2. Press ALARM to view the alarm. (AL will show
at the top.)
3. Press and hold ALARM for 2 seconds.
12
The language options are (E) English,
will show