Bosch MSGP6 Gebrauchsanleitung Seite 18

en Troubleshooting
Accessory
VarioTray
Booster tray
Troubleshooting
Pump starts 1 to 7 times a day.
Normal watering cycle
Your device automatically performs op-
▶
timum watering.
Pump makes loud or unusual noises
compared with normal watering.
Too little nutrient solution in the water bowl.
Pour nutrient solution into the water
▶
bowl.
→ "Topping up with nutrient solution",
Page 16
Pump is blocked or furred up.
Descale and clean the pump.
▶
→ "Descaling the appliance", Page 16
→ "Cleaning the device", Page 17
18
Designation
MSGZSCT1
MSGZBT12
Use
Plant 2 different microgreens and 3 plant capsules
at the same time.
¡ Add 3 spoonfuls (6 g) of nutrients to 3 litres of
fresh tap water and pour into the water bowl.
¡ Assemble the watering unit. Replace the plant
tray with the VarioTray. Insert the watering unit.
¡ Place the contents of one microgreen seed bag
in each of the microgreen sections. Fit the mi-
crogreen cover.
¡ Insert 3 plant capsules in the openings.
¡ Place the light unit on the pump and insert the
power supply unit. The light unit lights up pink
and the sprouting phase begins.
¡ If the microgreens have sprouted after 2-4 days,
remove the microgreen cover and insert a height
module if necessary. The microgreens will be
ready for harvesting after around 7 days.
Replace the plant tray with the booster tray and, at
the same time, plant 12 plant capsules instead of
6.
Tip: Use closely growing plants from the same
growth group.
Light unit does not light up.
Device is not connected to the power
supply.
Check whether the power supply is
1.
plugged into a socket.
Check whether the connecting cable is
2.
properly connected to the pump.
Ambient temperature above 40 °C. The
overtemperature protection has switched
the device off.
Check whether the location is suitable in
1.
the long term.
→ "General information", Page 15
Close curtains or blinds to lower the
2.
room temperature.
If the room temperature has dropped
3.
below 36 °C, reset the device by dis-
connecting it from the power supply for
at least 5 minutes.
Sleep mode is switched on or lighting has
been switched off manually.
→ "Setting sleep mode", Page 16
1.