Herunterladen Inhalt Inhalt Diese Seite drucken

Konig KN-WS600 Anleitung Seite 9

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 10
HOME TIME, WORLD (ZONE) TIME
Hold "ZONE" to enter world (zone) time setting mode. Press "▲" or "▼" to enter the desired hour offset value
from –12 to +12 hours. Press "ZONE" to confirm each setting.
Press the "ZONE" button to toggle between home (radio-controlled) time and world (zone) time. The "ZONE"
icon appears when world (zone) time is selected. When zone time is not used, set the zone time to "0".
ALARM SETTING
Press the "ALARM" button to show the alarm time and the "ALARM" icon will appear. Press again to enable or
disable the alarm. The bell icon " " appears when the alarm is enabled.
Hold "ALARM" to enter alarm time setting mode. Press "▲"or "▼" to enter the desired Hour/ Min values and
press "ALARM" to confirm the setting.
SNOOZE AND BACKLIGHT
When the alarm is going off, press SNOOZE/ LIGHT to trigger the snooze function and the "Zz" icon will
appear. To stop the alarm for one day, press the "ALARM" key.
In normal display, press SNOOZE/LIGHT for an extended backlight if the adapter is not connected.
LOW BATTERY INDICATION
Low battery indication is available for the monitor itself and all of the remote sensors. Replace the batteries
and follow the setup procedure in this instruction manual.
Important: Wind direction calibration is required for the anemometer during battery replacement (For details,
refer to the "Calibrating the anemometer and installing batteries" section).
BATTERY DISPOSAL
Replace only with the same or equivalent type recommended by the manufacturer.
Please dispose of old, defective batteries in an environmentally friendly manner in accordance with the
relevant legislation.
SPECIFICATIONS
Indoor temperature:
Outdoor temperature:
Temperature resolution:
Indoor and outdoor humidity:
Humidity resolution:
Channel for temp and humidity:
Wind speed range:
Rain gauge reading:
Transmission (anemometer):
Transmission (rain gauge):
Clock:
Power:
Safety precautions:
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage caused
due to incorrect use of this product.
0°C to + 50°C (+32°F to +122°F)
-20°C to +60°C (-4°F to +140°F)
0.1°C
20% – 99% RH
1% RH
Maximum 3
0 – 30 m/s
0 – 108 km/h
0 – 67 mph
0 – 58.3 knot
0 – 11 Beaufort
0 – 9999 mm
0 – 393.66 inch
Up to 100M (328 feet) in open area, RF433 MHz
Up to 50M (164 feet) in open area, RF433 MHz
DCF77 Radio-Controlled, Quartz back-up
AA x 6 pieces for the monitor (not included); optional 6.0 V Adapter;
AA x 2 pieces for the anemometer (not included)
AA x 2 pieces for the rain gauge (not included)
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
9

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis