Chain Lubrication - Volpi KVS8000P Benutzerhandbuch

• Screw (to increase the tension) or unscrew (to decrease the tension) the chain tension adjustment screw
③.
• By helping you with the protective gloves, pull the chain down and check that the guide links of the chain
are still visible for half the height in the lower part of the bar.
• If the guide links are fully visible when pulling the chain down, or if they are not visible at all, it means
that the tension is incorrect.
• Repeat the adjustment.
• Tighten the two locknuts ①.
Warning!
The chain pinion must not be disassembled by the user, but by at a specialized service center.
If the chain pinion is damaged, do not use the chainsaw and take it to a specialized service center.

15.5. Chain Lubrication

The chainsaw is equipped with an automatic oil pump that allows to keep the chain lubricated and cooled.
To fill the oil tank, follow the instructions.
• Disconnect the battery from the chainsaw.
• Place the chainsaw in a horizontal position with the oil cap facing upwards.
• Clean the oil cap, the tank and the surrounding environment with a damp cloth.
• Unscrew the oil cap and remove it.
• Fill the tank to the appropriate level and prevent it from overflowing.
• Firmly screw the oil cap.
Warning!
The chain lubrication is adjustable (see chapter 7.2).
The set values are the optimal ones for the correct operation of the chainsaw.
To check the correct operation of the oil pump, turn on the chainsaw and check if there are traces of oil
on the ground below.
If there are not traces of oil, check to have refilled the tank.
47