INSTALLATION Produktempfang Die Geräte i.Am werden als Transporteinheit in einem Schutzkarton mit Schrumpffolie auf einer Holzpalette angeliefert. Mit dem Produkt wird im Temperierschrank folgendes Material geliefert: – Installations, Betriebs und Wartungsanweisung – Schlüssel für Schloss Die Anweisung ist wesentlicher Bestandteil des Produkts. Sie muss vor dessen Installation und Inbetriebnahme gelesen und sorgfältig für künftigen Bedarf bzw.
Installationsraum Der Installationsraum hat den technischen sowie gesundheitlichen Vorschriften und geltenden Bestimmungen zu entsprechen. Stellen Sie das Gerät an einem trockenen und ausreichend belüfteten Ort auf. Insbesondere: – Vermeiden Sie die Aufstellung des Geräts in der Nähe von Wärmequellen (Heizkörper, Backöfen, Herde usw.) oder Zugluft. –...
Seite 4
VERBOTEN Situationen NEIN! NEIN! Zurück gegen die Wand Geschlossene Aussparung Abb. 6 Gewährt Situationen ✓ Abb. 7 Bezeichnung H1200 H1600 H2000 A (mm) B (mm) C (mm)
Seite 5
Installation Transport Packen Sie das Gerät folgendermaßen aus: – stellen Sie das Gerät in der Nähe des Installationsraums auf – führen Sie die Gabeln (1) des Handhubwagens ein und heben Sie das Gerät etwas an – lösen Sie die Schrauben (2) an jedem Sockel (3) und nehmen Sie sämtliche Sockel der Palette ab –...
Seite 6
Aufstellung und Nivellierung – Ziehen Sie das Gerät mit kleinen Bewegungen auf den genauen Installationsstandort – neigen Sie das Gerät mit größter Vorsicht leicht seitlich und stellen Sie die Füße (8) ein – überprüfen Sie die einwandfreie Öffnung der vorderen Tür. Abb.
2 INSTALLATION Receiving the product i.Am cabinets are delivered in a single pack, wrapped in shrink-wrap film inside a cardboard box. The following material is also supplied, inside the cabinet: – Installation, operation and maintenance manual – Keys for the door lock This manual is an integral part of the appliance.
Place of installation The place of installation must conform to all applicable technical and health standards. Position the appliance in a dry, well ven- tilated place. In particular: – Do not position the appliance near sources of heat (radiators, ovens, cookers, etc.) or in draughts. –...
Seite 9
FORBIDDEN positions Back against wall Narrow niche Fig. 6 PERMITTED positions ✓ Fig. 7 Description H1200 H1600 H2000 A (mm) B (mm) C (mm)
Seite 10
Installation Moving Proceed as follows to remove the packaging from the appliance – Move the appliance near the place of installation – Steer the forks (1) of the pallet transporter under the appliance and lift it just clear of the floor –...
Positioning and levelling – Move the appliance into its final installation position, proceeding in small steps at a time – Very carefully tilt the appliance and adjust the feet (8) – Make sure that the door of the cabinet opens properly. Fig.