Balluff BNI CIE-508-105-Z015 Betriebsanleitung Seite 68

8 Transient transmission
Gateway parameter
data
www.balluff.com
Parameter data for the device can be set regardless of the port configuration.
Byte Item Initial
operation
setting
Default: 0h
Read/Write
Access 11h
code
Address 00h
code
1
Size
[word]
0: WITH
0-1 Data
1: WITHOUT
Unused
2-3
Initial operation setting: WITHOUT: No Initial processing request flag necessary. After
booting up the device goes to "Ready" mode. The ports are configured as inputs. WITH:
The device can only be brought to "Ready" mode by means of the "Initial processing
request flag".
Output Hold/Clear: HOLD: The last state of the outputs is held when the module is
disconnected from the fieldbus network or the CPU is in the STOP state. CLEAR: The
outputs are reset when the named events occur.
Number of ON times: Number of the respective active pin. E.g. if Pin 2 Port 0 was turned
on 5 times, this value is stored here. You may reset this value if needed or set it to other
values.
Output Number of ON
Hold / Clear times
0 to 4294967295
Default: 0h
Default: 0h Read/Write
Read/Write
12h 13h
00h 00h-07h
1 2
0: CLEAR Pin 4
1: HOLD
Unused Pin 2
25