Supra CERAMINO 1522 Gebrauchsanleitung Seite 8

Power I
Ceramino 600W
1522
Ceramino 800W
2022
HEATING FUNCTION
Your CERAMINO gentle heat convector heater
combines a number of technologies for en-
hanced comfort. The heating elements inside
the convector heater are described below:
1st core: rapid response electrical resistor for
convection heating.
2nd core: ceramic block for gentle radiant
heat, exclusively designed for enhanced radi-
ation.
Setting I (b) : ceramic block operation. Gives
off gentle heat by radiation.
Setting II (c) : electrical resistor operation.
Allows an extremely fast heat-up time thanks to
natural convection. The heat is dispersed from
the top of the heater.
Setting III (d) : simultaneous operation of the
ceramic block (b) and the electrical resistor (c).
Heat is dispersed from the top of the appliance.
CERAMINO 1522 (1500W)
Turn the selection knob (A) to select the de-
sired power setting :
I (600W) : ceramic heating element (b)
II (900W) : heating wire element (c)
III (1500W) : ceramic+ heating wire elements
working together (d)
Set the temperature with the thermostat (B)
Once the room has reached the desired tem-
perature, turn the thermostat knob anti-clock-
wise until you hear a «click». The desired tem-
perature has now been programmed.
CERAMINO 2022 (2000W)
Turn the selection knob (A) to select the de-
sired power setting :
I (800W) : ceramic heating element (b)
II (1200W) : heating wire element (c)
III (2000W) : ceramic+ heating wire elements
working together (d)
Set the temperature with the thermostat (B)
Once the room has reached the desired tem-
perature, turn the thermostat knob anti-clock-
Power II Power III
900W 600+900 =
1500W
1200W 800+1200
=2000W
wise until you hear a «click». The desired tem-
perature has now been programmed.
HUMIDIFIER FUNCTION
Open the top cover of water tank in the back
cover inside product, and fill water inside (E).
Close the water tank cover and turn on the
heater.
When the water level is low, fill in water tank
again, if you want to continue humidifying the
room.
WARNING: When filling the water, please turn
heater off and remove plug. Do not splash
water on the product.
WARNING: Only use demineralised water to fill
the tank. Do not use perfumes, essences, oils
or other flammable liquids.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE
Select the minimum position (MIN) using the
thermostat control.
Stop the appliance, selecting position 0 on the
selector control (A)
Unplug the appliance from the mains.
Put the cable back in the cable housing.
The cable housing means you can remove and
have available the required length of cable for
working with the appliance, preventing accident
risk situations.
Clean the appliance.
CABLE COMPARTMENT
This appliance has a cable compartment situat-
ed on its posterior (C)
CARRY HANDLE/S
This appliance has a handle on the side of the
body, which facilitates comfortable transport.
(F)
ANTI-TIPPING SAFETY DEVICE
The appliance has an anti-tipping safety device
that turns it off if the working position is not the
correct one.
SAFETY THERMAL PROTECTOR
The appliance has a safety device, which pro-
tects the appliance from overheating.
When the appliance switches itself on and off
repeatedly, for reasons other than the ther-
mostat control, check to ensure that there are
no obstacles that impede correct air entry or
expulsion.