Installing The Heater - Zibro R 263 T Gebrauchsanweisung

This transportation
cap is packed sepa-
rately in the box.
Only this cap ensures
trouble-free trans-
portation of the hea-
ter after use.
Store it well!
B
C
D
E
F
Using the right fuel is therefore essential for safe, efficient, and comfortable use
of your heater.
Damage and/or malfunctions of the heater due to the use of other than high qua-
lity water-free pure paraffin oil is not covered by the warranty.
Always refer to your local dealer for the right fuel for your heater.
MANUAL
A

INSTALLING THE HEATER

1 Carefully remove your heater from the box and check the contents.
In addition to the heater you also need to have:
a transportation cap
these directions for use
Keep the box and the packaging materials (Fig. A) for storage and/or
transportation.
2 Remove the other packaging materials:
Release the right side of the grill ¶ from the two slots by pulling the right
side of the grill to the left and then pull it forward (Fig. B).
Pull both ends of the packaging to the rear and at the same time slightly
downwards (see Fig. C).
Remove the combustion chamber from the heater and remove the pac-
kaging underneath (see Fig. D).
Put the combustion chamber back into its place. The combustion chamber
is positioned correctly when it can be smoothly moved a little to the left
and to the right by its handle ´ (Fig. F). Close the grill: Slightly lift it to
reposition it in its slot.
Open the lid of the removable tank º and remove the piece of cardboard.
A
4
65