General Directions For Use - Zibro R 263 T Gebrauchsanweisung

GENERAL DIRECTIONS FOR USE

Below you will find the main steps to be taken for
using your heater. For more details, please refer to
the MANUAL (pages 65 ff.).
1
Remove all packaging materials (refer to Section A, Fig. A).
2
Fill the removable tank ¾ and wait 30 minutes before you
ignite the heater (refer to Section B, Fig. G).
3
Insert the batteries into the battery holder ¹
(refer to Section A, Fig. F).
4
Check whether the combustion chamber ¿ is fully upright
(refer to Section A, Fig. E).
5
Ignite the heater by turning the knurled wick adjustment
knob · as far to the right as possible and then gently push
the ignition button » (refer to Section C, Fig. K and L).
6
After igniting the heater it will take 10 to 15 minutes before
you can check if the heater burns well (refer to Section D).
7
Switch off the heater (refer to Section E).
• As a fire precaution, the tank must be filled either
er has been switched off or in another room than the room where
the heater is installed.
• Always ensure that the tank is closed properly after filling it at a safe
distance from all sources of heat and open flames (see chapter B).
• Store all fuel containers
and dark place.
• Fuel ages. Use ne fuel at the start of every heating season.
• The use of Zibro Extra, Zibro Kristal or Zibro Bio as a heating fuel
assures you that you have a good quality fuel.
• Before changing brands and/or types of fuel make sure that the
mobile heater first completely empties all of the remaining fuel
inside the heater.
ith their original caps and seals in a cool
MAIN COMPONENTS
³
·
»
´
²
¶
º
hen the heat-
¾
µ
¸
¹
OFF - button
Knurled wick
adjustment knob
Ignition button
Combustion
chamber
Combustion
chamber handle
Fuel indicator
Grill
Lid for removable
tank
Removable tank
Fuel gauge
removable tank
Ignition coil
Battery holder
4
63