Before Use - Supra PTC606E TINO CERAM Gebrauchsanleitung

EN
(Original instructions)
Wall and mobile heater
TINO CERAM
DESCRIPTION
A. Control panel
B. Air outlet
C. ON/OFF switch
D. Remote control
1. LED display
2. Comfort mode
3. Eco mode
4. ON/OFF button
5. ON LED
6. Heat intensity
7. Timer
8. Modes
9. Increase
10. Decrease
I. ON/OFF button
II. Increase
III. Timer
IV. Modes
V. Heat intensity
VI. Decrease
If the model of your appliance does not have
the accessories described above, they can
also be bought separately from the Technical
Assistance Service.
USE AND CARE
Fully extend the appliance's power cable
before each use.
Do not use the appliance if the on/off switch
does not work.
Do not move the appliance while in use.
Use the appliance handle/s, to catch it or move
it.
Do not use the appliance if it is tipped up and
do not turn it over.
Do not turn the appliance over while it is in use
or connected to the mains.
If you use the appliance in a bathroom or
similar place, unplug the appliance from the
mains when it is not in use, even if it is only for
3-EN.indd 1 3-EN.indd 1
a short while, as proximity to water involves a
risk, even if the appliance is disconnected.
Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
Do not store the appliance if it is still hot.
Do not store the appliance on areas where the
temperature could be lower than 2ºC.
Make sure that dust, dirt or other foreign
objects do not block the fan grill on the
appliance.
Never leave the appliance unattended while
in use.
Never leave the appliance connected and
unattended if is not in use. This saves energy
and prolongs the life of the appliance.
Do not use the appliance to dry pets or
animals.
Do not use the appliance to dry textiles of any
kind.
CAUTION: User can't sleep when appliance is
under use; there is a risk of injuries.
Turn the thermostat control to the minimum
(MIN) setting. This does not mean that the iron
is switched off permanently.
ASSEMBLING THE WALL BRACKET
Securing to the wall (Fig.1): Use a pencil to
mark the right position to drill the wholes for the
wall plugs.
Make sure the diameter of the wholes
corresponds to the diameter of the wall plugs.
Drill two wholes on the areas previously
marked
Insert the wall plugs into the wholes.
Once the wall plugs have been fitted into the
wall, screw the two screws
Make sure the screws are well fixed before
hanging the appliance.
Use the wholes behind the appliance to hang it
from the two screwheads.
Ensure that the appliance is properly and
safely fixed in its working position with the
screws.
The appliance has a wall bracket (?) on which
it can be supported.
INSTRUCTIONS FOR USE

BEFORE USE

31/3/22 18:17 31/3/22 18:17