Kenwood DNX7200 Installations-Handbuch Seite 4

Connection
8 6 4
7 5 3
8 6 4
7 5 3
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
4 |
DNX7200
Ground wire (Black)
Battery wire (Yellow)
2
1
Ignition wire (Red)
2
1
Connect to the vehicle's parking
brake detection switch harness
using the supplied relay connector.
Parking sensor wire (Light Green)
PRK SW For the sake of safety, be sure to connect the parking sensor.
To vehicle's reverse lamp harness
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
To "EXT.AMP.CONT. " terminal of the amplifier
having the external amp control function.
If no connections are made, do not let the cable come out from the tab.
Antenna Cord (ISO)
(Orange/White)
Reveres sensor wire (Purple/White)
Steering remote control input
(Light Blue/Yellow)
To steering remote
Mute wire (Brown)
Power control/ Motor antenna control wire
(Blue/White)
External amplifier control wire (Pink/Black)
FUSE ( 5A )
Antenna Conversion
Adaptor (ISO-JASO)
(Accessory 7)
Dimmer control wire (Orange/White)
ILLUMI