Inventum IVW6015A Benutzerhandbuch Seite 48

Problem
There is food waste left on the
dishes.
There are white stains on the dishes.
The dishes are not dry.
There are rust stains on the dishes.
48 • English
Possible cause
The appliance is not loaded correctly
and the spray arms cannot reach all
the dishes.
The cutlery basket is too full.
The dishes are placed too close
together.
The amount of detergent is
insufficient.
The selected program is not suitable
for the loaded dishes.
One of the spray arms is clogged.
The filters are clogged.
The filters are not placed correctly.
The water drain pump is clogged.
The amount of detergent is
insufficient.
The level of rinse aid consumption is
set too low.
There is a high level of water
hardness and no salt is used.
The level of water hardness is
set too low, which affects the salt
consumption.
The cap of the salt reservoir is not
closed correctly.
The selected program does not
include drying.
The level of rinse aid consumption is
set too low.
The appliance is unloaded too
quickly after the program is finished.
The stainless steel quality of the
dishes is insufficient.
Possible solution
Make sure that you load the
appliance correctly. Refer to section
Loading the appliance
.
Make sure that you load the
appliance correctly. Refer to section
Loading the appliance
.
Make sure that you load the
appliance correctly. Refer to section
Loading the appliance .
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
detergent reservoir
.
Choose a suitable program. Refer to
Programs
section .
Clean the spray arms. Refer to
Cleaning the spray arms
section
Clean the filters. Refer to section
Cleaning the filters
.
Make sure that you correctly place
the filters.
Make sure that the water drain pump
is not clogged.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
detergent reservoir
.
Adjust the level of rinse aid
consumption. Refer to section
Setting the level of rinse aid
consumption
.
Fill the salt reservoir. Refer to
Filling the salt reservoir
section
Adjust the level of salt consumption.
Setting the level of
Refer to section
salt consumption
.
Make sure that the cap of the salt
reservoir is closed firmly.
Choose a program that includes
Programs
drying. Refer to section
Adjust the level of rinse aid
consumption. Refer to section
Setting the level of rinse aid
consumption
.
Wait a few minutes after the program
is finished before you unload the
appliance.
Make sure that you only clean
dishwasher-safe dishes in the
appliance.
Filling the
.
Filling the
.
.