AEG RKB333E2DW Benutzerinformation Seite 32

32 www.aeg.com
Problem
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily.
The lamp does not work.
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Possible cause
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor‐
rectly.
The appliance is not level‐
led.
You attempted to re-open
the door immediately after
closing.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
During the automatic de‐
frosting process, frost melts
on the rear plate.
Door was open too frequent‐
ly.
Door was not closed com‐
pletely.
Solution
Refer to the "Installation"
chapter.
Allow food products to cool
to room temperature before
storing.
Refer to the "Closing the
door" section.
Refer to the installation in‐
structions.
Wait a few seconds between
closing and re-opening of
the door.
Close and open the door.
Contact the nearest Author‐
ized Service Centre.
Refer to the "Closing the
door" section.
Refer to the "Closing the
door" section.
Wrap the food products bet‐
ter.
Refer to the "Operation"
chapter.
Set a higher temperature.
Refer to the "Operation"
chapter.
Set a higher temperature.
Refer to the "Operation"
chapter.
This is correct. Dry the water
with a soft cloth.
Open the door only when
necessary.
Make sure the door is closed
completely.