Black & Decker MTJS1 Originalanweisungen Seite 6

ENGLISH
Charge only at ambient temperatures between 10 °C and
u
40 °C.
Charge only using the charger provided with the tool.
u
p When disposing of batteries, follow the instructions given
u
in the section "Protecting the environment".
Do not attempt to charge damaged
batteries.
Chargers
Use your BLACK+DECKER charger only to charge
u
the battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
$
u
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
Tool shown is MT218. Other tools are available for use with
this tool head.
This tool includes some or all of the following features.
10. Jigsaw head
11. Blade clamp
12. Blade clamp lever
13. Shoe
Assembly
Warning!
Before assembly, remove the battery from the tool
and make sure that the saw blade has stopped. Used saw
blades may be hot.
Fitting and removing the saw blade (fig. A)
Lock the tool by setting the forward/reverse slider (2) to
u
the centre position.
6
(Original instructions)
To fit a saw blade, press the blade clamp lever (12) down
u
(located at the rear of the jigsaw head) and hold it in this
position.
Insert the saw blade into the blade clamp (11) as shown.
u
Make sure that the teeth are point-ing to the front.
Release the lever.
u
To remove the saw blade, press the blade clamp lever
u
(12) down and pull the saw blade from the holder.
Use
Warning! Let the tool work at its own pace. Do not overload.
Warning! Never use the tool when the saw shoe is loose or
removed.
Sawing
Note: Ensure the forward reverse slider (2) is not in the
locked position.
To switch the tool on, press the variable speed switch (1).
u
The tool speed depends on how far you press the switch.
To switch the tool off, release the variable speed switch.
u
Hints for optimum use
General
Use a high speed for wood, a medium speed for
u
aluminium and PVC and a low speed for metals other than
aluminium.
Sawing laminates
As the saw blade cuts on the upward stroke, splintering may
occur on the surface closest to the shoe plate.
Use a fine-tooth saw blade.
u
Saw from the back surface of the workpiece.
u
To minimise splintering, clamp a piece of scrap wood or
u
hardboard to both sides of the workpiece and saw through
this sandwich.
Sawing metal
Be aware that sawing metal takes much more time than
sawing wood.
Use a saw blade suitable for sawing metal. Use a finetooth
u
saw blade for ferrous metals and a coarser saw
blade for non-ferrous metals.
When cutting thin sheet metal, clamp a piece of scrap
u
wood to the back surface of the workpiece and cut through
this sandwich.
Spread a film of oil along the intended line of cut.
u
Accessories
The performance of your tool depends on the accessory used.
BLACK+DECKER accessories are engineered to high quality
standards and designed to enhance the performance of your