Assembling The Speaker Stand - Eclipse 508DMK3 Bedienungsanleitung

- Assembling the speaker stand -

1
Assemble the base plate and the column using the pan
head screws.
Caution
Securely tighten the pan head screws.
Tip
Fix the base plate to the column by fitting the two pan
head screws in the shaped holes, with the round feet
towards the floor.
2
Assemble the bracket and the column using the pan
head screws.
Caution
･ Be sure to assemble the bracket as shown in the
illustration so that it faces as shown in the illustration at
right. If it is fitted any other way, the stand will fall over,
and damage to the speaker or personal injury may result.
･ Securely tighten the pan head screws.
Typical assembly
diagram
Speaker cone
Align with the direction of
the speaker cone
3
Insert the locking pin of the speaker into the hole in the
bracket, and then tighten it using the speaker angle
adjustment nut.
Caution
･ Do not touch the cone material while carrying out
adjustments or the driver could be damaged.
･ Securely tighten the speaker angle adjustment nut.
･ Be careful not to damage the base of the speaker
when placing the speaker onto the stand.
Tip
･ Insert the locking pin into the hole in the bracket, and
align the three pins with the grooves in the speaker.
･ B e f o r e t h e s p e a k e r a n g l e a d j u s t m e n t n u t i s
tightened, the angle of the speaker can be adjusted.
For details, refer to "Adjusting the speaker angle" on
the next page.
❷
Column
Grooves X3
Pins X3
Allen key (large) (included with speaker)
− 11 −
❸
Base plate
❹
Pan head screw X2
Foot
❹
Pan head screw X2
❶
Bracket
❷
Column
Speaker
Locking pin
❶
Bracket
Speaker angle adjustment nut