Technical Data; Before Starting The Equipment - EINHELL TE-DA 18/760 Li Originalbetriebsanleitung

4. Technical data

Motor power supply ................................ 18 V DC
Idling speed ........................................0-560 min
Feed speed ............................................0.13 m/s
Length of cleaning coil ............................... 7.6 m
Diameter of cleaning coil ............................ 7 mm
Pipe diameter ..................................... 16-55 mm
Weight .....................................................3.65 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 62841.
L sound pressure level ........................ 79 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level .......................... 90 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841.
Handle
Vibration emission value a
K uncertainty = 1.5 m/s
The stated vibration emission levels and stated
noise emission values were measured in ac-
cordance with a set of standardized criteria and
can be used to compare one power tool with
another.
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
Warning:
The vibration and noise emission levels may vary
from the level specifi ed during actual use, depen-
ding on the way in which the power tool is used,
especially the type of workpiece it is used for.
Anl_TE_DA_18_760_Li_SPK13.indb 16 Anl_TE_DA_18_760_Li_SPK13.indb 16
-1
= 0.895 m/s
2
h
2
- 16 -
GB
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Limit the operating time!
All stages of the operating cycle must be conside-
red (for example, times in which the electric tools
are switched off and times in which the tool is
switched on but operates without load).
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Warning!
Always remove the battery before making adjust-
ments to the machine.
6. Operation
6.1 Adjusting the direction of rotation and
movement of the cleaning coil (Fig. 5)
The machine has two controls for adjusting the
cleaning coil: the Forward/Neutral/Reverse lever
(2) and the direction of rotation switch (3).
The direction of rotation and movement of the
cleaning coil (1) will change depending on how
the controls are set.
23.02.2022 13:24:14 23.02.2022 13:24:14