Safety Devices On The Grinder-Doser; Residual Risks - Fiorenzato F64 E Installations-, Benutzer- Und Wartungsanleitung

EN

3.4 Safety devices on the grinder-doser

All grinder-dosers manufactured by Fiorenzato M.C. S.r.l. are equipped with
appropriate mechanical and electromechanical devices to protect the safety
of the user and the integrity/functionality of the appliance during use.
The grinder-dosers in the ON DEMAND line are equipped with the following safety
devices:
• Motor thermal cut-out
The motor of the appliance has a thermal cut-out which protects it against
overheating due to overcurrents and intervenes by interrupting the power supply
to the motor.
• Cooling fan (Fig. 3)
Only the grinder-doser models F64 EVO and F71 EK have a cooling fan on the back
of the machine body to prevent overheating of the grinding blade drive motor. This
fan is activated electronically. On some models the fan starts after each dispensing
process and remains active for 60 seconds, whereas on other models the fan starts
when dispensing starts and stops when grinding stops.
• Anti-intrusion device on coffee supply hopper (Fig. 4)
The anti-intrusion device (Part. 1) inside the supply hopper (Part. 2) allows the
coffee beans to pass through to the grinding chamber, preventing operators from
accidentally inserting their fi ngers.
• Safety adjustment disk lock lever (Fig. 5)
To prevent any accidental rotation of the grinding adjustment disk (Part. 1), there is
an adjustment disk lock lever (Part. 2) on the rear.
1
1 2
Fig. 3
14 / 44 EN
ON DEMAND line
1
2
Fig. 4 Fig. 5
Fiorenzato | ON DEMAND_00 line Ed. 03/2022
ON DEMAND line

3.5 Residual risks

Fiorenzato M.C. S.r.l. has taken all necessary precautions during the design phase to
ensure that the grinder-doser can be used under the safest possible conditions. However,
during installation, cleaning and maintenance of the appliance, there are still some
residual risks that cannot be eliminated. Their effects can be prevented by appropriately
training the user in accordance with the provisions set out in the table below.
For each residual risk, provisions are indicated to limit and/or eliminate the extent of
individual risks.
Residual risk Present during:
Handling the appliance
when:
• Unpacking.
Bruising and/or
• Installing.
crushing of the
• Handling the
upper and lower
appliance to clean
limbs due to the
the surface on which
weight of the
it stands.
appliance.
• Connecting and
disconnecting the
power supply cable.
Electrocution
Fiorenzato | ON DEMAND_00 line Ed. 03/2022
EN
Provisions for reducing the risk
• Grip the appliance fi rmly before
handling it.
• Make sure you have enough
space to handle the appliance
safely without hitting any
obstacles.
• Use non-slip gloves if
necessary when handling the
grinder-doser.
• Check the condition of the
power cable frequently and
replace it when it appears to be
deteriorated or damaged.
• Make sure that the switch is in
the 'O' (OFF) position before
connecting the power cable to
the grinder-doser.
15 / 44 EN