Error Messages - Meec tools 011712 Bedienungsanleitung

EN

ERROR MESSAGES

Error
message
E1
E3
E4
E5
E6
E7
E8
E9
30
Symptom/possible cause
Overcurrent protection
1. Power consumption too
high (over 50 A ± 4 A >
500 ms).
2. The product is defective.
The product does not start.
1. Some other reason
prevents the product from
starting.
2. The product is defective.
Overload protection
1. Overload.
2. The product is defective.
Overheating protection
If the product is used
continuously for a long time
it can overheat, whereby the
overheating protection trips and
switches off the product.
Undervoltage protection
The voltage is too low (less than
14 ± 0.5 V).
Hardware fault
Motor failure
Surge protection
1. The voltage is more than
30 V.
Proposed action
1. Switch off the product.
2. Start the product again.
3. Contact the retailer if the product still does
not work properly.
1. Switch off the product.
2. Start the product again.
3. Contact the retailer if the product still does
not work properly.
1. Switch off the product.
2. Start the product again.
3. Contact the retailer if the product still does
not work properly.
Switch off the product and allow it to cool for at
least 30 minutes before starting it again.
Charge the battery, or replace with a fully
charged battery.
1. Switch off the product.
2. Start the product again.
3. Contact the retailer if the product still does
not work properly.
1. Switch off the product.
2. Start the product again.
3. Contact the retailer if the product still does
not work properly.
1. Check that the battery voltage is < 21 V.
2. Use the specified type of batteries.