Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
accessory. After inspecting and install-
ing an accessory, position yourself and
bystanders away from the plane of the
rotating accessory and run the power
tool at maximum no-load speed for one
minute. Damaged accessories will nor-
mally break apart during this test time.
• Wear personal protective equipment.
Depending on application, use face
shield, safety goggles or safety glasses.
As appropriate, wear dust mask, hear-
ing protectors, gloves and workshop
apron capable of stopping small abra-
sive or work¬piece fragments. The eye
protection must be capable of stopping
flying debris generated by various oper-
ations. The dust mask or respirator
must be capable of filtrating particles
generated by your operation. Prolonged
exposure to high intensity noise may
cause hearing loss.
• Keep bystanders a safe distance away
from work area. Anyone entering the
work area must wear personal protec-
tive equipment. Fragments of work-
piece or of a broken accessory may fly
away and cause injury beyond immedi-
ate area of operation.
• Never lay the power tool down until the
accessory has come to a complete
stop. The spinning accessory may grab
the surface and pull the power tool out
of your control.
• Do not run the power tool while carrying
it at your side. Accidental contact with
the spinning accessory could snag your
clothing, pulling the accessory into your
body.
• Regularly clean the power tool's air
vents. The motor's fan will draw the
dust inside the housing and excessive
accumulation of powdered metal may
cause electrical hazards.
• Do not operate the power tool near
flammable materials. Sparks could
ignite these materials.
• Do not use accessories that require
liquid coolants. Using water or other
liquid coolants may result in electrocu-
tion or shock.
6
Attention: The sander is not designed for
wet sanding.
• Do not immerse the machine in liquids
• Make sure the sanding paper is cor-
rectly in place before switching on.
• Avoid moving parts while working.
There is danger of injury!
• Never sand materials containing
asbestos.
• Please note that poisonous dust may
be formed e. g. when sanding paint,
which contains lead, while processing
some kinds of wood or metal. The dust
forming during operation may be haz-
ardous to your health, combustible or
explosive. Wear safety goggles, dust
protection and ear protection
3. Before use
• Remove any packing material and loose
parts from unit.
• Check the accessories before use. It
should be fit with the machine and your
purpose.
• If the machine is new, the battery must
first be charged.
• Battery is housed in the handle, press
the battery retention clips, and remove
battery from handle.
• A substantial drop in operating period
per charge indicates that the battery is
worn out and must be replaced.
Attention! After long time storage, the bat-
tery capacity will be reduce.
Battery charger
• The power voltage supply must con-
form to that specified on the rating
plate of the rapid charger.
• Always inspect battery charger, cord
and plug before use.
• Always have damage repaired by a
qualified professional.
• Protect battery charger against humid-
ity and operate only in dry areas.
• The supplied charger is suitable for
charging batteries only.
4. During use
• Hold power tool by insulated gripping
surfaces (7), during operation when the
Werbung
Inhaltsverzeichnis
