TJEP KYOCERA C-RINGER Bersetzung Der Original Bedienungsanleitung Seite 12

C-ring bounce out
C-ring fall out of jaw
Tool does not actuate, when
trigger is pulled
Strange sound during
actuation
Strange sound in motor or
slow actuation
Smoke coming from tool
For failure other than above situations, please stop using the tool and contact your local TJEP dealer for service.
12
Magazine assembly worn or
damaged
Pusher damaged
Jaws damaged
Obstacle in C-ring groove
of jaw
Tightness of jaws is not the
same
Problem with C-rings:
1. Burr on surface of C-rings
2. Crooked strip
3. Uneven strip
4. Bent or deform C-ring
5. Asymmetry
6. Bad adhesion of collation
tape (C-rings fall off)
PCB assembly damaged.
1. Lack of lubrication
2. Motor assembly damaged
1. PCB assembly damaged
2. Motor assembly damaged
1. PCB assembly damaged
2. Motor assembly damaged
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Clean the groove of jaws – see the section jam release
Contact your TJEP dealer for repair
Use good quality C-rings
Contact your TJEP dealer for repair
Clean and lubricate tool
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair