Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Bracket installation when wiring is outside the wall:
1. Carefully poke through the
semicircular thin wall on the
corresponding side of the wire.
4. Remove the lamp cover and
holding-ring.
7. Fix the lamp to the bracket
with the Φ3*12 mm screws.
2. Drill 2 holes with a 6 mm diameter
and 35 mm deep according to the
spacing of the lamp bracket holes.
(Use screw anchors when needed)
5. Attach the lamp to the bracket.
8. Replace the lamp cover and reattach
it to the base with the Φ2.3*8 mm
screws.
7
3. Place the wiring through the hole
created on the side, then through the
base of the bracket. Fix the bracket on
the wall with the Φ3,8*30 mm screws.
6. Connect the desired power
supply (12-24 V AC/DC or
85-265 V AC).
9. Replace the holding ring. The
installation is now complete!
Werbung
