Overheating Protection; Maintenance Of The Appliance - EBECO Wall Flex 500 Handbuch

Overheating protection

The appliance is equipped with a safety device that switches off the heater automatically at extreme temperatures i.e. overheating
of the appliance. The unit automatically resets the operation of the heater when the temperature drops below the permissible
values.
Cleaning
It is mandatory to first switch off the appliance and, if possible, disconnect it from the power socket before cleaning. You should
then wait until the convector has cooled down in the disconnected position. Clean the appliance and its ventilation openings with
a damp cloth, vacuum cleaner or brush. In order not to damage the coating, solvents, thin or hard abrasive products should never
be used when cleaning. Never immerse the appliance in water as this poses a risk to your life due to electric shock.
Storage
Disconnect the convector from the power socket and then allow it to cool down. Use the original packaging of the appliance when
storing for prolonged periods. Store the convector in a dry and dark place and protected from direct sunlight. It must not be stored
in damp and wet premises.

Maintenance of the appliance

Contact your dealer in case of malfunction.
Heated surface
Guaranteed minimum heated room volume at the average heat transfer factor λ = 0.5 W/(m2K), at a ceiling height of 2.5 metres.
Part no. Watt
85 012 01 600
85 012 03 1000
85 012 05 1400
* Dimensions including wall bracket.
645 mm
805 mm
2
< m mm*
9 342 x 645 x 80
13 342 x 805 x 80
18 342 x 1070 x 80
1000 W
600 W
1070 mm
1400 W
342 mm