Feature Description; Blade Opening Mode; Storing The Shear; Troubleshooting - CAMPAGNOLA SL23 Bedienungs- Und Wartungsanleitung

5.2.2

Feature description:

Once the optional function is engaged, for it to be operational, it is necessary for the operator, when working near the curtain
wire, to grasp the vegetation and/or shoot support wire with his free hand at a MINIMUM distance of 15 cm from the cutting
point of the branch, i.e. from the blades of the shear.
DANGER
It is a mandatory requirement to always maintain a distance of AT LEAST 15 cm between the hand holding the
curtain wire and the branch or shoot to be cut in order to avoid a risk of injury to the operator's limbs.
Contact between the free hand and the curtain wire should preferably be through the use of conductive metal gloves.
Under these conditions, if the blade accidentally touches the curtain wire, cutting stops and the blade returns to the open
position, thus avoiding accidental damage to the wire and consequent repair costs.
Any other use of this optional function other than the above is not permitted by the Manufacturer and is prohibited as well
as constituting misuse of the tool.
The Manufacturer accepts no liability for damage to property or personal injury due to improper, unauthorised use of the
tool and/or use not in accordance with the operating instructions supplied with the tool.
DANGER
Depending on the characteristics of the operations to be carried out, improper use of the tool involves consid-
erable risks and is prohibited.
5.2.3

Blade opening mode

Switch the shear on and press the trigger twice: the blade is 100% open.
With the shear on, keep the trigger pressed until a beep is heard: the blade is 70% open.
Return to 100% blade opening by keeping the trigger pressed until the beep is heard again.
5.3

Storing the shear

• Hold the trigger down for a few seconds until 3 long beeps are emitted. The blade closes and stays closed. Release the
trigger.
• Switch off the shear and remove the battery.
• Recharge the battery before storing it inside the box.
• Clean the shear and place it and its components in the box.
• Store the shear in a dry place.
• If the tool is not used for long periods, recharge the batteries every 3 months at the latest.
5.4

Troubleshooting

CAUTION!
All extraordinary maintenance shall be carried out by a mechanical maintenance technician.
DANGER
The tool supplied must only be used by qualified and trained operators by reading and understanding this manual
and only in accordance with the recommendations contained therein.
FAULT
The shear cannot com-
plete the cut.
The battery does not
charge fully.
Electrical/mechanical mal-
function.
The shear does not oper-
ate.
CAUTION!
Failure to comply with the instructions in the manual may cause damage or injury.
Use and maintenance manual – Instructions
Original instructions Rev. : 00 Date 01/07/2022
CAUSE
Branch beyond the permitted diam-
eter or wood too hard.
• Degraded battery.
• Faulty battery charger.
• Unsuitable battery charger.
• Motor overheating.
• Noisy shear.
Potential electronic or mechani-
cal problem.
SOLUTION
Release the trigger immediately. The movable blade will
return to the open position.
• Check that the battery charger is the one supplied with
the shear.
• Replace the battery.
• Replace the battery charger.
Take the shear to a Service Centre authorised by the
Manufacturer.
Take the shear to a Service Centre authorised by the
Manufacturer.
Page 29