Cleaning And Care - oneConcept SG003 Bedienungsanleitung

EN
14
Dissolve washing powder directly
1. Add the washing powder when the water level is low.
2. Select a programme.
3. Start the machine and let the water mix for 1 minute.
4. After the washing powder has dissolved completely, you can let in more
water.
5. Select the correct washing time.

CLEANING AND CARE

• Disconnect the unit from the mains. Observe the safety instructions when
doing so.
• After you have drained the water from the washing drum, set the
controller from "Pump out" back to "Standard".
• Remove the lint filter and disassemble it by pressing on the bottom from
the inside. Clean the lint filter in warm water.
• Reassemble the lint filter after cleaning, put it back in place. Once it is
seated properly, you will hear a click.
• Disconnect the appliance from the water inlet and attach the drain hose to
the appliance.
• Rub down the casing. Use only mild cleaning agents for this.
• Close the cover and place the washing machine in a well-ventilated place.
Important cleaning instructions
• The electrical components of the appliance must not come into contact
with water during maintenance.
• If the power cable is damaged, it must be replaced immediately by a
specialist workshop.