Avision Network Box MB01W Schnelleinrichtungsanleitung Seite 8

5. The main window of Avision Capture Tool appears. Press [Scan] to start scanning. In a
second, the scanned image will be displayed.
Important:
Make sure the LAN cables have been connected properly on your switching hub FIRST and
then connect the power of the Network Box. Otherwise, other computers in the network may
obtain IP address from the Network Box and therefore may not connect to the internet.
Scan from A Wireless Computer in Direct Share (AP) Mode
1. On your computer, click the Wi-Fi Network icon in the taskbar and select the network
name –MB-xxxx (xxxx is where the last four digits of the Mac address on the label on the
Network Box). (Note by default no network password is required. You can designate a
network password through Network Box's embedded web page later.)
2. Follow step 1 to 5 described in the preceding section [Scan from a Wired Computer] to
complete a scan.
Important:
When using the bundled software Avision Capture Tool to scan, you may be prompted with the
message "Can not find scanner". Please wait a while and try again as the scanner may be
warming up or communicating with Network Box.
8