Avision Network Box MB01W Schnelleinrichtungsanleitung Seite 3




"LAN" Port: Used to connect the LAN cable to the Network Box for wired
network connection.

"5VDC 1.5A" Port: For scanner without a 24VDC power jack, use this port to
connect the box to a USB power adapter via a Micro USB cable.

"24VDC IN" Port: Used to connect the power adapter that comes with the
scanner to the Network Box.

"WPS" Button: Press to use WPS (Wi-Fi Protected Setup
access point which supports WPS. Press the WPS button of your Access
Point, and then press and hold the WPS button of Network Box for 5 seconds
until the Status LED flashes in red to start the WPS connection.

"Reset" Button: Restore the network security settings to factory default. To
reset the Network Box, use a pen to press and hold this button for about 5
seconds until the blue network LED turns off. Wait for about 30 seconds until
the blue Network LED turns on and starts blinking again.



TM
) to connect to an
3