Waeco CoolMatic CB-36 Bedienungsanleitung Seite 25

_CB_RHD_Kühlboxen.book Seite 25 Montag, 20. Dezember 2004 11:24 11
CB-36, CB-40, RHD-50
➤ Before starting up the device for the first time, check whether the
operating voltage and the battery voltage correspond (see type plate).
➤ Connect the cooling device
– As directly as possible to the pole of the battery or
– To a plug socket which is fused with at least 15 A (at 12 V) or 7.5 A
(at 24 V).
Caution!
Disconnect the cooling device and other power consuming
devices from the battery before connecting the battery to a quick
charging device.
Overvoltage can damage the electronics of the device.
The cooling device is equipped with an electronic device to protect against
reversing the polarity and short circuits when connecting to a battery.
To protect the battery, the cooling device switches off automatically if the
voltage is insufficient (see table below).
Switch-off voltage
Switch-on voltage
Connecting to 230 V mains supply
Danger of fatal injuries!
Never handle plugs and switches with wet hands or if you are
standing in a puddle.
If you are operating your cooling device on board a boat with a
mains connection of 230 V from the land, you must install a
ground protection circuit breaker between the 230 V mains supply
and the cooling device.
Seek advice from a trained technician.
➤ To operate the cooling device with a 230 V mains supply, use an EPS-100
W or MPS-35 MOBITRONIC rectifier.
Installing and connecting the cooling device
12 V
10.4 V
11.7 V
24 V
22.8 V
24.2 V
25