auna W2-AC400 Bedienungsanleitung Seite 18

EN
18
CONNECTION
1. Connecting the power cable
• As this is a high-current device, the correct connection of the power
cable is very important.
• Connect the red cable to the (+) terminal of your battery using the cable
with the fuse holder.
• Connect the black cable firmly to a screw or another part of the
bodywork of your car after you have removed the coating from this
area. This is necessary for proper earthing.
• Proper wiring results in clear sound.
2. Connection of the remote on/off cable
• Connect the orange cable to a switched power cable of the car radio.
This controls the switching on and off of the amplifier.
• The cable for the automatic antenna on the radio (if present) can be
used for this purpose.
3. Amplifier input connection
• This unit can be used with all car radios that have high-power outputs.
• Separate basic car radio connection: Connect the car radio speaker
output cables to the high-power inputs +/- right and left.
• General car radio connection: Connect the negative car radio speaker
output cable to the two remaining cables +/- right and left.
4. Connecting the AUX port
• Connect the AUX input cable to the RCA connector as described:
• "White" to the left RCA output and "Red" to the right RCA output of the
car radio.
• Before connecting the RCA output of the car radio or other equipment,
make sure that the impedance and sensitivity match this AUX
connection.