Technical Specifications - Polar FD169 Bedienungsanleitung

EN
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not
working
The appliance turns on,
but the temperature is
too high/low
The appliance is
leaking water
The appliance is
unusually loud
on display

Technical Specifications

Model Voltage Power
FD169
220-240V~ 150W
50Hz
8
FD169_ML_A5_v1_20220517.indb 8 FD169_ML_A5_v1_20220517.indb 8
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Too much ice on the evaporator
Condenser blocked with dust
Doors are not shut properly
Appliance is located near a
heat source or air flow to the
condenser is being interrupted
Ambient temperature is too high
Appliance is overloaded
The appliance is not properly
levelled
The discharge outlet is blocked
Movement of water to the drain is
obstructed
The water container is damaged
The drip tray is overflowing
Loose nut/screw
The appliance has not been
installed in a level or stable
position
Unit in state of "Emergency power
supply" due to power off
Temperature
Current
Range
0.7A 2°C ~ 8°C
Solution
Check the unit is plugged in correctly and
switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Defrost the appliance
Clean the condenser
Check door is shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Reduce the amount of medicines stored
Adjust the screw feet to level the appliance
(if applicable)
Clear the discharge outlet
Clear the floor of the appliance
(if applicable)
Replace the water container
Empty the drip tray (if applicable)
Check and tighten all nuts and screws
Check installation position and change if
necessary
Check mains power supply
Net Dimensions
Refrigerant
Capacity H x W x D mm
58L R600a 855 x 600 x
(55g)
Weight
(kg)
44
595
2022/5/17 13:57 2022/5/17 13:57