Timer; Emergency Operation For Wireless Remote-Controller (Option); Filter Preparation - Mitsubishi Electric Mr. SLIM PEA-M200LA Bedienungshandbuch

4. Timer

■ Timer functions are different by each remote controller.
■ For details on how to operate the remote controller, refer to the appropriate operation manual included with each remote controller.
4.1. For wireless remote controller
ON/OFF
MODE
CHECK
TEST RUN
SET

5. Emergency Operation for Wireless Remote-controller (option)

HEAT

6. Filter Preparation

• Install an optional filter or a locally procured filter at the air inlet.
For the filter installation or maintenance procedures, see the usage
instructions for the filter.
10
Ⓒ
Ⓓ
Ⓑ
Ⓐ
TEMP
FAN AUTO STOP
①③
VANE AUTO START
LOUVER h
②
min
RESET CLOCK
AAA
AAA
ON/OFF
①
②
COOL
1) Set the current time
① Press the CLOCK button using a thin stick and blink the time Ⓐ .
② Press the h and min button to set the current time.
③ Press the CLOCK button using a thin stick.
2) Set the time to start the unit as follows
AUTO START
① Press the button.
• Time can be set while the following symbol is blinking.
On time: Ⓑ START is blinking.
• The start times is displayed at Ⓐ .
h min
② Use the and buttons to set the desired time.
③ To cancel the ON timer, press the
3) Set the time to stop the unit as follows
① Press the AUTO STOP button.
• Time can be set while the following symbol is blinking.
Off time: Ⓒ STOP is blinking.
• The stop times is displayed at Ⓓ .
h min
② Use the and buttons to set the desired time.
③ To cancel the OFF timer, press the
4) Changing the set times
AUTO START AUTO STOP
Press the or to cancel the timer and repeat from 2) or 3).
① ON/OFF lamp (lit when unit is operating; unlit when unit is not
operating)
② Emergency operation
In cases where the remote control unit does not operate properly, use
either the COOL or HEAT button on the wireless remote control
signal receiver to toggle the unit on or off. On cooler only units,
pushing the HEAT button toggles the fan on and off.
Pressing the COOL or HEAT button selects the following settings.
Operation mode
Preset temperature 24 °C/75 °F
Fan speed
AUTO START
button.
AUTO STOP
button.
COOL HEAT
24 °C/75 °F
High High