Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting the fingerprint (only for 120FP & 210FP)
•
Open the door and press the reset button once.
•
You will hear 2 short buzzer sounds and see a yellow light flashing.
•
Place your finger on the fingerprint sensor and then remove it.
•
You will hear 2 buzzer tones and see a yellow light flashing.
•
Repeat the previous step two more times.
•
Finally, you will hear a long beep, which means that the new fingerprint has been successfully registered.
ATTENTION: A maximum of 30 fingerprints are supported!
Please use the same finger when registering fingerprints!
To improve the rate of correct finger identification, you can follow the advice below:
We recommend that each user register 2-3 fingerprints.
We recommend women and children to register with thumb and middle finger.
Try to press with even force.
In very dry weather, we recommend breathing on the fingers until they are a little wet.
Switch between single and double entry mode (only for 120FP & 210FP)
•
Open the safe.
•
Press "1" on the keypad and the reset button at the same time.
•
You will hear a long buzzer tone.
•
This means that the switch between single and double entry mode was successful.
Alarm - Wrong code
•
If 3 incorrect code entries or 5 incorrect fingerprint entries are made, a warning tone sounds for 20 seconds.
ATTENTION: You can stop the beeps by entering the correct code or fingerprint within 20 seconds.
Alarm - Shake alarm
•
Press "*" while the unit is in sleep mode.
•
then the vibration alarm system is activated.
•
The safe will sound an alarm for 20 seconds if it is moved or shaken.
•
You can stop the alarm by entering a password or fingerprint (only for 120FP & 210FP).
Restoring the factory settings
•
Open the safe.
•
Press the reset button and hold it down for 8 seconds.
•
You will hear a long beep.
•
The safe is reset to the factory settings.
In the factory settings, the user code is "1234" and the master code is "123456" and any fingerprint (only for 120FP
& 210FP) will allow the safe to be opened.
ATTENTION: In the factory settings, the safe is in single-entry mode.
Turning the sound off/on
•
Press "0" twice and "*" once to activate mute mode.
•
Press "6" twice and "*" once to end the mute mode.
ATTENTION: The safe is in mute mode when the battery is low. Alarm beep is still activated during mute mode.
10
Werbung
Inhaltsverzeichnis
