Olymp GOsafe 120FP-Serie Bedienungsanleitung Seite 10

Removing the batteries
Follow the steps below to remove the batteries.
Remove the battery compartment cover.
Caution! Danger of short circuit.
• Remove batteries only with a non-conductive object, e.g. a wooden or plastic spatula.
Remove the batteries.
Replace the battery compartment cover.
External battery source
•
delivery).
•
•
ATTENTION: Only for emergency operation!
Closing the door
• Close the door of the safe
• Turn the knob anticlockwise to close the door.
Open door with user code or master code
• Enter the registered user/master code (4 to 8 digits).
• Then press the "#" key.
• You will hear two short buzzer sounds and see the green light turn on.
• Turn the knob clockwise to open the door.
ATTENTION: The preset user code is "1234" and the preset master code is "123456"!
Opening the door with fingerprint (only for 120FP & 210FP)
• Press the fingerprint sensor on the control panel with the registered finger.
• You will hear two short buzzer sounds and see the green light come on.
• Turn the knob clockwise to open the door.
ATTENTION: In factory setting mode, the door can be opened by any fingerprint!
Opening the door with user code or master code and fingerprint (only for 120FP & 210FP)
• Press the fingerprint sensor with the registered finger.
• You will hear 2 short beeps and see the green light flashing.
• Then enter the user/master code and press the "#" button within 10 seconds.
• You hear 2 short buzzer tones and the green light lights up.
• Turn the knob clockwise to open the door.
Setting the user code
• Open the door and press the reset button once.
• You will hear 2 short buzzer sounds and see the yellow light flashing.
• Then enter the new user code (4 to 8 digits) and press "#" to confirm.
• You will hear 2 buzzer tones, which means that the new user code has been set successfully.
ATTENTION: Please leave the door open until the test of the new code has been successfully completed!
Setting the master code
• Open the door, press the "0" twice and the reset button once.
• You will hear 3 short buzzer sounds and see the yellow light flashing.
• Then enter the new master code (4 to 8 digits) and press "#" to confirm.
• You will hear 2 buzzer tones, which means that the new master code has been set successfully.
ATTENTION: Please leave the door open until the test of the new code has been successfully completed!
9V battery can be used as an external power source. (9V battery not included in the scope of
Remove the lower black sticker from the keypad.
Place the 9V battery until the metal contacts under the keypad are in contact.
9