Closing The Door - Olymp GOsafe 5300-Serie Bedienungsanleitung

Low battery level
If the display shows "LO-BATTE", this means that the batteries have a low voltage and you should insert new
batteries immediately.
Replace the batteries by arranging them as indicated by the "+" and "-" signs.
Removing the batteries
Follow the steps below to remove the batteries.
Remove the battery compartment cover.
Caution! Danger of short circuit.
• Remove batteries only with a non-conductive object, e.g. a wooden or plastic spatula.
Remove the batteries.
Replace the battery compartment cover.

Closing the door

When you close the door, the handle is automatically turned to the horizontal position. The safe is closed and
locked.
ATTENTION: for GOsafe 5300 & 5300FP, GOsafe 5350 & 5350FP, GOsafe 5500 & 5500FP the handle must be turned
clockwise (upwards) manually to close the door.
Open door with user code or master code
• Press the "LOCK" button to activate the safe.
• Enter the registered user code (3 to 8 digits).
• OPEN" appears on the display.
• Turn the handle counterclockwise (downwards) to open the door.
ATTENTION: The preset user code is "159".
Opening the door with fingerprint (only for 5300FP series)
• Press the fingerprint sensor on the control panel with the registered finger.
• OPEN" appears on the display.
• Turn the handle counterclockwise (downwards) to open the door.
ATTENTION: In factory setting mode, the door cannot be opened with a fingerprint!
Setting the user code
• Open the door and press the reset button once.
• You will hear a short beep.
• You will see the display and the fingerprint scanner (only for 5300FP series) flash.
• Then enter a new user code (3 to 8 digits).
• Press "LOCK" to confirm.
ATTENTION: Please leave the door open until the test of the new code has been successfully completed!
Opening the door with a hidden user code
• Press "Lock" once to activate the safe.
• Then press "Clear" once before entering the code.
• As you enter the code, it disappears from the LCD display.
Setting the fingerprint (only for 5300FP series)
• Open the door and press the reset button once.
• You will hear a short beep.
• You will see the display and the fingerprint scanner flashing.
• Place your finger on the fingerprint scanner and remove it.
• You will hear 1 beep.
• Repeat the fingerprint scanning process two more times.
• Finally, you will hear 2 beeps and see the fingerprint scanner flash twice.
• The new fingerprint has been successfully registered!
11