Floor Heater Thermoup Floor/Led Plus; Heater Design; What's Included In The Set; Installation And Connection - ThermoUp Floor Bedienungsanleitung

FLOOR HEATER
THERMOUP FLOOR/LED PLUS

Heater design

Power button
Cord socket
Power cord (1.8m)

What's Included in the set

1. Heater;
2. Detachable electric power cord for heater;
3. Control panel;
4. Operating manual and warranty card.
Binding of remote controller with the heater is carried out
on a manufacture. If there is no heater response on the
remote controller please repeat connection procedure in
accordance with the instruction.

Installation and connection

1. Unbox the device.
2. Place it on the floor or any other flat surface.
3. Plug the removable power cord into the
appropriate part on the device, then plug the
power cord into an electrical outlet.
4. Press the heater power button to put the device
into operation.
5. Set the required power of the instrument using
the regulator.
FLOOR HEATER THERMOUP FLOOR
Figure 1. Heater ThermoUp Floor/LED Plus
Setting a new control panel
1. Switch off the power to the heater using the button on the side
panel of the heater: when switched off, it does not glow.
2. In the upper left corner of the control panel, press and hold
the «Power on» button.
3. Turn on the power to the heater with the button on its side
panel.
4. Release the button on the control panel. The setting is
complete.
If you have replaced the remote control, the setting procedure
must be repeated.
Thermoelement (glass)
Aluminium base
19