Usage Instructions - Arregui BE Bedienungsanleitung

USAGE INSTRUCTIONS

1. FIRST USE
• Open the safe box using the emergency key (see point 6).
• Insert the four batteries in the battery compartment.
• Programme the codes.
2. PROGRAMMING THE PERSONAL CODE
IMPORTANT: The door must be open.
• Press the red (RESET) button located on the back of the
door. The yellow (OPERATION) LED will turn on and be
followed by a beep.
• Enter desired personal code (3 - 8 digits).
• Press the <E> button to confirm. The yellow LED will turn
off and be followed by a few beeps. The new code has been
programmed.
3. PROGRAMMING THE MASTER CODE
IMPORTANT: The door must be open.
• Press <0 - 0>.
• Press the red (RESET) button located on the back of the
door. The yellow (OPERATION) LED will turn on and be
followed by a beep.
• Enter new master code (3 - 8 digits).
• Press the <E> button to confirm. The yellow LED will turn off
and be followed by a few beeps.
• The new master code has been programmed.
NOTE: You should always write down programmed codes.
4. OPENING THE SAFE BOX
• Enter personal code (1 - 2 - 3 - 4) when opening for the
first time.
• Press the ON button. The green (OPEN) LED will turn on and
be followed by two beeps.
• Turn the knob or handle clockwise and open the safe box.
NOTE:
If you enter an incorrect code, the yellow LED will turn on and
be followed by a few beeps.
If an incorrect code is entered three consecutive times, the
safe box will be blocked for three minutes
A5 instrucciones BE_HE1_HE2.indd 8
5. CLOSING THE SAFE BOX
• Close the door.
• Turn the knob or handle in the opposite direction.
6. OPENING WITH THE EMERGENCY KEY
The safe box is also equipped with a manual emergency
opening system. You will need to remove the cap located on
the door keypad to access the lock. Insert the key and turn
anti-clockwise, and turn the knob or handle clockwise to open
the door.
IMPORTANT
Never leave the emergency key inside
the safe box
7. BATTERY
• Powered by four 1.5-volt batteries (AA LR6), included with
your safe box, located on the back of the safe box door.
• When the batteries run out, a red LED will turn on. You
should replace them as soon as possible.
8. MAINTENANCE
Check the condition of the battery compartment on a regular
basis (every 6 months) to identify any possible signs of rust,
sulphation, etc.
Grease/oil any mechanical moving parts, such as locks and
bolts.
En
24/11/20 15:16