Care And Maintenance; Disposal - KAN-therm AC ECO Bedienungsanleitung

4

Care and Maintenance

Disconnect the plug from the socket before carrying out any work on the machine.
Check that the press jaws are fully functional. Damaged press jaws must not be used and must
be sent to an authorised KAN-therm repair shop.
Check that the press jaw and drive rolls move freely.
Check the bolt for signs of damage at regular intervals. Have damaged bolts replaced by an au-
thorised KAN-therm repair shop.
Clean and grease the drive rolls, the bolt and press jaws when you have finished work.
Use only high quality pressing or ball bearing grease.
The pressing contour must be kept free of grease.
All other servicing, maintenance and repair work must be carried out by an authorised KAN-
therm repair shop.
If the seal is damaged the warranty will be null and void.
After 10.000 pressing cycles or 1 year have the machine serviced by an authorised KAN-therm
workshop.
Send the machine to the workshop in the carry case only.
Electro-hydraulic machine does not exceed 3 hours in a -5° C storage.
5

Disposal

Components of the unit are recyclable material and should be put to recycling. For this purpose
registered and certified recycling companies are available. For an environmental friendly dispos-
al of the non-recyclable parts (e.g. electronic waste) please contact your local waste disposal
authority.
For EU countries only:
Do not dispose electric tools with domestic waste. In accordance with the European
Directive 2012/19/EU the disposal of electrical and electronic equipment and its im-
plementation as national law, electric tools that are no longer serviceable must be
collected separately and utilised for environmentally compatible recycling.
ENGLISH 13