Operation (D); Care And Maintenance; Disposal - KAN-therm AC 3000 Bedienungsanleitung

3.6 Operation
Use only system-compatible press fittings and press jaws designed for them. The nominal size
of the press jaw must be identical with the nominal size of the press fitting.
When inserting the pipe / press fitting system, there is a risk of crush injuries for the
fingers or other body parts near the press jaw!!
 Push the press fitting on to the pipe (1). Pull the press jaw apart and insert the pipe with the
press fitting at right angles.
There must be no foreign bodies between the press contour and the fitting. If you fail to
ensure this, the pressing process will not produce a perfect joint!
 Press the ON button until the pressing process has been completed (2). The motor cut out
indicates the end of the moulding cycle.
 Push the press jaw apart and take the machine off the joint (3).
Do not start the machine while the piston retracts or the emergency shutdown is pressed!
4

Care and Maintenance

Disconnect the plug from the socket before carrying out any work on the machine.
Check that the press jaws are fully functional. Damaged press jaws must not be used and must
be sent to an authorised KAN-therm repair shop.
Check that the press jaw and drive rolls move freely.
Check the bolt for signs of damage at regular intervals. Have damaged bolts replaced by an au-
thorised KAN-therm repair shop.
Clean and grease the drive rolls, the bolt and press jaws when you have finished work.
Use only high quality pressing or ball bearing grease.
The pressing contour must be kept free of grease.
All other servicing, maintenance and repair work must be carried out by an authorised KAN-
therm repair shop.
If the seal is damaged the warranty will be null and void.
After 20.000 pressing cycles or 2 years have the machine serviced by an authorised KAN-therm
workshop.
Send the machine to the workshop in the carry case only.
Electro-hydraulic machine does not exceed 3 hours in a -5° C storage.
5

Disposal

Components of the unit are recyclable material and should be put to recycling. For this purpose
registered and certified recycling companies are available. For an environmental friendly dispos-
al of the non-recyclable parts (e.g. electronic waste) please contact your local waste disposal
authority.
For EU countries only:
Do not dispose electric tools with domestic waste. In accordance with the European
Directive 2012/19/EU the disposal of electrical and electronic equipment and its im-
plementation as national law, electric tools that are no longer serviceable must be
collected separately and utilised for environmentally compatible recycling.
ENGLISH
(D)
13