Function Of The Unit; Mains Connection; Emergency Stop Button (A); To Switch On (B) - KAN-therm AC ECO Bedienungsanleitung

The quoted vibration and noise emissions can vary during actual use of the electric
power tool dependent on the way in which the electric power tool is used, in particular
what type of workpiece is being processed.
Establish additional safety measures to protect the operator which are based upon an
estimate of the vibration loading during the actual usage conditions (in doing so taking
account of parts of the operating cycle, for example times in which the electric power
tool is switched and those in which it is switched on but not running under load).
3

Function of the Unit

3.1

Mains connection

Connect only to single-phase alternating current and only to the mains voltage specified on the
rating plate. The machine may also be connected to sockets without an earth contact since it
complies with protection class II.
3.2 EMERGENCY STOP button
If there is any danger to personnel or the machine during the pressing process, press the
EMERGENCY STOP button immediately and release the ON switch. The valve will open and
the piston will return to its initial position.
3.3 To switch on
Press one of the two ON buttons until the pressing process has been completed.
3.4 To insert the press jaw
Disconnect the mains plug!
 Open the bolt.
 Insert the appropriate press jaw for the job in hand.
 Lock the bolt.
After changing the crimping jaw it is essential to ensure that once engaged, the crimping jaw
matches the profile being moulded and the nominal width of the fitting being moulded. A visual
inspection must be carried out in order to determine that the crimping jaw is fully closed at the
end of the moulding cycle.
3.5 To turn the press jaw
The press jaw can be turned through 270° depending on the application.
3.6 Operation
Use only system-compatible press fittings and press jaws designed for them. The nominal size
of the press jaw must be identical with the nominal size of the press fitting.
When inserting the pipe / press fitting system, there is a risk of crush injuries
for the fingers or other body parts near the press jaw!
 Push the press fitting on to the pipe. Pull the press jaw apart and insert the pipe with the
press fitting at rightangles.
There must be no foreign bodies between the press contour and the fitting. If you fail to
ensure this, the pressing process will not produce a perfect joint!
 Press one of the two ON buttons until the press cycle has finished, then release the ON but-
ton.
 Push the press jaw apart and take the machine off the joint.
Do not start the machine while the piston retracts or the emergency shutdown is pressed!
12 ENGLISH
(A)
(B)
(C)
(D)
(E)