Main Connection; Function Of The Unit; Emergency Stop Button (A-1); To Switch On (A-2) - KAN-therm AC 3000 Bedienungsanleitung

The quoted vibration and noise emissions can vary during actual use of the electric
power tool dependent on the way in which the electric power tool is used, in particular
what type of workpiece is being processed.
Establish additional safety measures to protect the operator which are based upon an
estimate of the vibration loading during the actual usage conditions (in doing so taking
account of parts of the operating cycle, for example times in which the electric power
tool is switched and those in which it is switched on but not running under load).
2.1

Main connection

Connect only to single-phase a.c. current and only to the system voltage indicated on the rating
plate. It is also possible to connect to sockets without an earthing contact as the design con-
forms to safety class II.
3

Function of the Unit

3.1 EMERGENCY STOP Button
If there is any danger to personnel or the machine during the pressing process, press the
EMERGENCY STOP button immediately and release the ON switch. The valve will open and
the piston will return to its initial position. The motor switches off after about 10 seconds.
3.2 To switch on
Press the ON button until the pressing process has been completed. The motor cut out indicates
the end of the moulding cycle.
3.3 To turn the press jaw
The press jaw can be turned through 270° depending on the application.
3.4 LED
The white LED's lights up by starting the press cycle (up to 30 sec. after end of the press cycle).
The white LEDs flash: after 20,000 pressing processes the LEDs flash after every pressing
process as an indication of the need for the next inspection. An internal counter keeps a record
of the number of pressing since leaving the factory.
3.5 To insert the press jaw
Disconnect the mains plug!
 Open the bolt (1).
 Insert the appropriate press jaw for the job in hand (2).
 Lock the bolt (3).
After changing the press jaw it is essential to ensure that, once engaged, the crimping jaw
matches the profile being moulded and the nominal width of the fitting being moulded. A visual
inspection must be carried out in order to determine that the press jaw is fully closed at the end
of the press cycle.
12 ENGLISH
(A-1)
(A-2)
(A-3)
(B)
(C)