Maintenance And Care; Information On Environmental Protection; Contact Information - Eufab 17520 Bedienungsanleitung

5.2 MOUNTING THE SMARTPHONE HOLDER
Before mounting, check whether the smartphone holder is suitable
for the selected mounting point, see Pictures 2 to 4.
Picture 2: Secure mounting not possible
Picture 3: Secure mounting not possible
max. 40 mm
Picture 4: Mounting possible
Open the spring clamp (position 4 in the overview), Picture 5 and
place the smartphone holder onto the dashboard of your vehicle.
Picture 5: Opening the spring clamp
Proceed as follows when mounting to the sun visor or the rear-view
mirror.
✗
✗
✓
5.3 FITTING THE SMARTPHONE INTO THE HOLDER
Squeeze the locks (position 2 in the overview) together. The
holding clamps 8position 1 in the overview) move apart. Place
your smartphone between the holding clamps. Release the lock
again, your smartphone is now a xed in the holder.
The holder can be turned so that the display is either upright or
crosswise. You can set the tilt angle with the holding arm (position 3
in the overview), Picture 6.
Figure 6: Inserting the smartphone
In the case of leather-coated or foamed surfaces, there
is a risk of permanent dents, especially when there are
high temperatures on the inside. Therefore remove the
smartphone holder, whenever it is not needed.

6. MAINTENANCE AND CARE

The smartphone holder for cars is maintenance-free when used
in accordance with the intended purpose. Clean the smartphone
holder for cars with a soft, dry cloth only. Do not use any aggressive
cleaning agents or solvent-based cleaners.

7. INFORMATION ON ENVIRONMENTAL PROTECTION

Dispose of the smartphone holder for cars in accordance with local
regulations.

8. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
5