IN & OUT HOUSE EF172D Bedienungsanleitung Seite 42

E N
The communication frequency between the unit and the remote control has
already been preset. If you cannot use the remote control with the unit, follow
the instructions "Set up communication between the remote control and the
unit" to re-establish the connection.
R E M OT E C O N T RO L'S S TA N D BY M O D E
The screen shows the remote control's standby mode.
S W ITC H O N/O F F
Press this button to switch the flame effect and the heater on or off. Press
this button to switch the flame effect on or off in daily or weekly timer mode.
F L A M E E F F E C T
Press to display the screen for adjusting the flame effect. Press the
button to select the three-level flame effect. Press the '+' and '-' buttons to
select the five levels of flame effect brightness and the OFF setting.
BAS E T R AY L E D LI G H T
Press the button to access the screen for adjusting the LED light in the base
tray. Press the
or a colour cycle mode. Press the '+' and '-' button to select the five brightness
levels for the lighting.
N O R M A L M O D E
The normal control mode is set at the factory. If this is not the case, press the M
button until the logo
'+' and '-' buttons to adjust the setting temperature from 17 °C to 25 °C in two
intervals. Press the button
displayed at the bottom of the screen.
N OT E: It is normal for the fan heater to stop running for some time. This
happens because the room temperature is at or above the temperature
set on the remote control. The heating indicator is switched off after
10 seconds when the flame is on. The heating indicator stays on when
you only use the heating function.
42
and button to toggle through the 13 colours of the LED light
is displayed in the upper corner of the screen. Press the
to switch the heater on and off. ON and OFF are
and