hillvert HT-LOGAN-1250B Bedienungsanleitung Seite 40

To clean the air filter:
- Remove the filter cover. Remove dirt and wash the cover.
- Remove the filter and check its condition. Wash it or replace it if it is damaged or
worn.
- Wash the filter in clean fuel and then squeeze it.
- Put and secure the filter in place, then put on the cover.
Idle speed adjustment
•
If necessary, adjust the idling speed to 3000 ±200 rpm.
- Start the engine and let it idle until the operating temperature is reached (2-
3 minutes).
- Use a screwdriver to turn the idle screw clockwise to increase the engine
idle speed.
- Turn the idle screw counterclockwise to reduce the engine idle speed.
Caution: Tubes must be installed when adjusting engine idle speed! Engine
idle speed is affected if intake cover or tubes are blocked, damaged or
incorrectly installed!
INSPECTION SCHEDULE
The Visual
whole inspectio
device n
(leakages,
fitness)
Cleaning
Control Operatio
handle n
inspectio
n
Air filter Cleaning
Each Aft After
time er refueli
befo use ng
re or
use dail
y
 

 
Onc Onc Eve
e a e a ry
we mon yea
ek th r
If a If If
probl damag requir
em e is ed
occurs detect
ed
