Led Lenser H7.2 Bedienungsanleitung Seite 4

LED LENSER® * H7
LED brightness. Left turn the brightness of LED
will getting lower or strobe slowly; right turn,
the brightness of LED will getting brighter or
strobe faster.
d) Boost Mode: in any state, push the front
switch for 2 seconds to achieve boost mode.
After 10 seconds the flashlight will return to the
previous setting.
The Light Functions above are in a loop.
Note that when switching modes, press the
"Multi-function Wheel" switch on the back for no
longer than 4 seconds, otherwise the product
will turn off.
6. "Transport Lock"
When the H7.2 is off, push the front switch for
approx. 5 seconds till the light turns off in order
to enable the "Transport Lock." Then the H7.2
cannot be turned on again. The H7.2 therefore
cannot be switched on; either intentionally or
unintentionally and inadvertently consume
energy.
To deactivate the "Transport Lock", just press
the front switch again for 5 seconds. The
headlamp will now return to the Light Program.
7. Reset function
If the alkaline batteries are taken out the battery
box you have "reset" the H7.2. You have thus
reset a few functions so that the "Transport
Lock" (see Section 6) is deactivated and the
Light Function Dim (see Section 5.1) is set to low
brightness.
8. Changing Alkaline Batteries
Prior to the change, turn off the H7.2.
On the back of the battery back, where the
headband is attached, there is the gate to the
inside of the battery box. Once you open the
battery box, there will be a silk tab that runs
underneath the battery. In order to remove the
battery pull the silk belt and then insert a new
one.
During insertion, it is always necessary that it is
in the correct direction. Therefore, pay attention
to the polarities (+ and -) both on the battery
box and the alkaline batteries. Otherwise, there
is a risk for damage batteries and a possible
explosion.
After replacing the batteries, the cover of the
battery box has to be put back into place.
To close the battery box, hold the battery box
and battery cover against each other in the
same direction, hook the battery cover above
the multi-function switch, and then push the
cover against the bottom, until you hear a small
"click" sound. Then push the middle of the cover
again, until you hear another "click". Now the
battery cover is securely closed.
9. Head Band
The headband can be washed by water.
Please refer to the picture to disassemble and
assemble the headband.
10. Batteries
Never use non rechargeable batteries and
accumulators together.
Always change all batteries at the same time.
In the H7.2, use only the alkaline batteries AAA/
LR03/Micro (1.5 V DC).
If you intend not to use the item for an extended
period, please take out the batteries to avoid
03
.2
damage.
Used batteries and accumulators have to be
taken out and disposed of in accordance to local
laws.
11. Cleaning
To clean, use a dry, lint-free, clean cloth.
If salt water is spilled on the head lamp, it must
be immediately entirely removed with such a
cloth.
The headband can be washed in a washing
machine at 30 °C.
12. Scope of delivery
The H7.2 headlamp is supplied with the
following accessories:
1 x H7.2 Headband
4 x AAA Alkaline batteries
1 x Manual
13. Caution
Do not swallow any small parts or batteries/
accumulators that are present. The products
or parts thereof (including batteries /
accumulators) must be stored out of the reach
of children.
For safety and approval reasons (CE), the
product must not be modified and/or changed.
The product is to be used exclusively as an
accumulator or battery powered lamp. If
the H7.2 is used for any other purpose, or
incorrectly, it can get damaged and a hazard-
free use is no longer guaranteed (danger from
fire, short-circuit, electric shock etc.) and
therefore there will be no liability for harm
anyone or damage to property. The warranty of
the manufacturer is also rendered null and void.
The H7.2 can be operated between -20 C° and
+50 C° (or between -4 F° and 122 F°). Ensure
that the H7.2 is not subjected to more extreme
temperatures, intense vibrations, explosive
atmosphere, solvents and/or vapors. Also
continuous exposure to direct sunlight, high
humidity and/or moisture must be avoided.
Changes, repairs and maintenance over and
above those described in the documents
accompanying the product may only be carried
out by authorized technical personnel.
If it is found that the product is filled with
full batteries / accumulators in the correct
orientation (polarity!) and properly closed, and
still unable to be function safely and normally,
or the product shows damage, it must be
rendered inoperable and not used any further.
In this case, for warranty matters, contact your
dealer.
14. Safety instructions
This product is not a children's toy.
Since it has small parts that can be swallowed,
it is especially not suitable for those under the
age of 5.
The article may not be used for examinations of
the eyes (e.g. for a pupil test).
When in use, heat accumulation, e.g. by
covering, must be avoided.
If the product does not work correctly, the first
thing that must be checked is whether this is
due to discharged or incorrectly placed battery/
accumulators.
If using in traffic, please follow the respective
legal regulations.