Package Contents; Problem Solving - KLAMER Classic Vacuum Pro 80 Bedienungsanleitung

Helpful Advice
1. Clean the inside and outside of the bag before sealing. Make sure
that the top of the bag is placed flat in the machine.
2. If you are vacuum sealing a larger object, carefully pull on the bag's
sides to avoid wrinkles.
3. Make sure that the bag is dry. It is very difficult to vacuum seal a
wet bag or wet bag edge.
4. For best preservation results, perishable food should be
refrigerated or frozen even after vacuum sealing it.
5. When vacuum sealing objects or food with sharp edges (such as
dry spaghetti, cutlery, etc.), wrap the bag in soft material such as a
paper towel to prevent damage. It may be better to use a container
instead of a bag.
6. Always leave at least 2.5 cm distance from the lid when using a
container.
7. Freeze fruits and vegetables before vacuum sealing for best results.
8. Remember to let the appliance cool down for 60 seconds after
each operation.
9. If you are not sure if a bag has been sealed correctly, you can simply
reseal it to be sure.
10. Microwave: Pierce the bag before heating it in the microwave.

Package Contents

NO. Description
1
Vacuum Sealer
2
AC Power Cord
3
Accessory Hose
4
Roll
5 Bag
6
Canister
7
Bottle Stopper
Image Qty
1
1
1
1 roll (28x300cm)
5 pcs (15x20cm)
Sold Separately
Sold Separately
21

Problem solving

Problem Possible cause
The vacuum sealer can't be The device is not connected
turned on to the power outlet
The device is damaged
The vacuum sealer is The lid is not fully closed
connected to the power
outlet, but vacuum sealing
The bag is not inserted
does not work
correctly
The bag is damaged
The vacuum nozzle is
damaged
The air was sucked out of The bag is damaged
the bag, but is now entering
again
The sealing strip is not
straight
The bag opening is too
moist
All the lights are on and the The vacuum sealer is
vacuum sealer does not overheated
respond
The device is damaged
Solution
Insert the power plug into a
grounded wall outlet
Contact the customer
service team
Close the lid so that it clicks
into place on both sides
Place the top opening of the
bag in the center of the
vacuum chamber
Replace the bag with an
undamaged one
Contact the customer
service team
Replace the bag with an
undamaged one
Check the sealing strip. Any
folds in the strip may be
responsible for air entering
the bag
If there is moisture or liquid
at the top of the bag, cut off
the wet area of the bag and
try again. area of the bag,
switch to "moist food" mode
and try again.
Disconnect the vacuum
sealer from the power
supply and allow it to cool
down for approx. 5-10
minutes. Then restore the
power supply
Contact the customer
service team
22